[ View Full Version Of This Page ]

2001 sebring conv 50k "No Bus"

All Forums » Chrysler Sebring » 2001 sebring conv 50k "No Bus"

mrb04
7/20/2007 4:04:56 PM
2001 sebring saying no bus and will not start has died twice and have been able to restart after cycling key a bunch but this time I don't thank it is going to restart. I have a OTC scan tool and can't comunicate with engine computor but does seem to work with everything else. any Ideas besides bad pcm
CHRYSLER TECH
7/20/2007 5:58:10 PM
SCI wires  U said u can talk to everything else  u arnt using a 99 buck scan tool are u? See if the pcm has power and ground. Unplug the pcm and see if u get teh bus back up  if it does  then yeah bad pcm.
mrb04
7/23/2007 7:44:34 PM
OTC genisys scanner. Other problem is after a few days the battery goes dead. If you charge it goes back down after a 2 or 3 days. Do you think the pcm is draining the battery. What wires should I check for power and ground. If I put in a salage yard pcm will the anti-theft and vin have to be programed at dealer? thanks fro the answers. 
CHRYSLER TECH
7/23/2007 9:28:14 PM
dont ever put junk yard computer in ne more  they will mess up more then u think. If u do have a drain put an amp meter on the batt and see what kinda amps are being pulled  factory max is 35ma. SO u can talk to other computers like airbag  and abs and bcm right?
mrb04
7/24/2007 6:26:17 AM
yes you can talk to abs and airbag also i think body control
CHRYSLER TECH
7/24/2007 6:33:26 AM
ok check the sci wires that are from the Datalink connector to the pcm see if thoes commucation lines are good  if so then u have a bad pcm. If u put a junk yarn PCM in it it had skim or vtss then all the other computer will know that and then on expect that to be there and u will have a no start and well  u get to replace ooo 3 or 4 different computers at once.
mrb04
7/26/2007 6:44:28 AM
I towed the car to chrysler to a friend that is a service advisor and said that the computers have I believe a 8/80 warrenty. The replaced the pcm just like I thought and car ran fine for about have a day 5 to 10 starts and stops. Now is doing the same thing again. This car also had a pcm put in it in march of 2006 according to dodge and the sticker on the side. What could cause the pcm to fail any ideas. thanks MIKE
CHRYSLER TECH
7/26/2007 9:36:11 PM
not really  do u have aftermarket stuff tied into the car some how?  HUmm  some times something like a cam or crank sensor will nuke the computers  seen that a few times.
Previous Thread: V6 Engine Noise
 
Next Thread:   Smoked Tail Light Covers?
Related Threads

[ View Full Version Of This Page ]

Return to the Chrysler Forum home page - Archive Home