karayj
1/21/2008 2:33:44 PM
I need help on the location the BRAKE PROPORTIONING VALVE on 2001 T&C van
Also if there are any special procedures x machanic in the 80/90's so i know quite a bit...
karayj
1/22/2008 5:56:02 AM
I think I found it under the rear cross bar
INSTALLATION - PROPORTIONING VALVE (HEIGHT SENSING)
- Install the end of the actuator rod through the axle bracket grommet and slide the proportioning valve bracket under the rear track bar body bracket (PROPORTIONING VALVE MOUNTING).
- Install the proportioning valve attaching bolts (PROPORTIONING VALVE MOUNTING). Tighten the attaching bolts to a torque of 54 N·m (40 ft. lbs.).
- Install the four chassis brake lines into the inlet and outlet ports of the proportioning valve (PROPORTIONING VALVE MOUNTING). Tighten all tube nuts to a torque of 17 N·m (145 in. lbs.).
CAUTION: The height sensing proportioning valve is not adjustable. No attempt should be made to adjust it.
- Bleed the brake system thoroughly to ensure that all air has been expelled from the hydraulic system. (Refer to 5 - BRAKES - BASE - STANDARD PROCEDURE).
- Lower the vehicle to the ground.
- Road test the vehicle to verify proper operation of the brake system.
