Fob remote code

Hi all.we live in south wales. New to forum. Just bought a voyager "W" 2000 and have a dodgy fob,bought a new one off e-bay, brand new and need to code it plz. Hope someone can help,and inturn if i can ever help,will do.

PROGRAMMING RKE MODULE

Using a functional key fob transmitter, unlock the vehicle and disarm the Vehicle Theft Security System.

Insert ignition key into the ignition switch.

Turn the ignition switch to RUN position without starting engine.

Using a functional key fob transmitter, press and hold the UNLOCK button for a minimum four seconds (maximum ten seconds)

While holding UNLOCK button, and before ten seconds passes, press and release the PANIC button. A single chime will sound to verify that the RKE module is set to receive the new Vehicle Access Code(s)

Within 30 seconds of the chime, press and release the "LOCK" and "UNLOCK" buttons on the transmitter at the same time. Then press any one of the buttons. The BCM will sound an abbreviated chime to acknowledge that the programming of the transmitter has been completed and was successful.

Repeat step 6 for all transmitters that will be used with this vehicle (up to 4 total)

Programming mode will last for 30 seconds. To get out of programming mode sooner, turn the ignition OFF. A single chime will sound to verify that the RKE module will no longer accept additional Vehicle Access Code(s)

When Vehicle Access Codes(s) programming is complete, turn the ignition switch to the OFF position and verify RKE system operation using each key fob NOTE: Only the two key fob transmitters that have been programmed to the memory seat and mirror system will operate it. If any key fob is replaced, the memory seat and mirror module will require programming. Refer to Group 8R-Power Seat Systems for proper (data link) programming with the DRB III® scan tool.

Hi, i recently recieved info regauding fob programing but it states press panic button?? any ideas where this is?? regaurds.

it would be red and say panic on it

Hi the fob only has 2 buttons on it one to open and one to unlock.

Will this process work for a 1999 Cirrus as well? If not, how do you program a new fob to that vehicle? Thank you.

how would i go about programming a new remote without having one already?

go to the dealer for that one

Thank you.