HELP with Removing Factory Radio and Door Speaker Please

Hello.  I just bought a 2006 Chrysler Sebring Sedan.  I would like to know how to remove the Factory CD Player and how to remove the Speaker Grills on the Door's so I can access the speakers.  Any help is greatly appreicated.  Sorry if this is a Stupid post.  I would just like to know how to do it without messing up my car.  Thanks Guy.

radio

1. Disconnect and isolate the battery negative cable.
   
2. Remove instrument panel center bezel trim.
   
3. Remove radio mounting screws.
   
4. Remove radio (RADIO).
   
5. Disconnect wire harness connectors. CAUTION: Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or radio.
   
6. Disconnect the antenna cable by pulling the locking antenna connector away from the radio (ANTENNA TO RADIO).

speakers
REMOVAL

1. Roll door glass down.
   
2. Disengage two clips attaching speaker grille to door trim panel. They are at the front of the grille, one near the top, and the other one at the bottom.
   
3. Remove three large washer-headed screws surrounding the speaker (Lower Door Trim Panel Removal).
   
4. Remove access cover at front of door trim panel. Remove by prying at its rear edge (Mirror Bezel and Door Trim Access Cover).
   
5. Remove red courtesy reflector from lower tail or door. Disengage by prying at screwdriver notch at bottom of reflector.
   
6. Remove flag trim panel from door by prying off at two attachment clips points (Mirror Bezel and Door Trim Access Cover).
   
7. Remove seven screws attaching door trim panel to door: (Lower Door Trim Panel Removal) and (Mirror Bezel and Door Trim Access Cover).
8. One screw is located at lower rear screw pocket.
   
9. Three screws located along the bottom of door.
   
10. One screw located inside handle opening.
    
11. One screw located at the upper front.
    
12. One screw in the pull cup.

Disengage two hidden clips attaching at the rear of the trim panel, by prying off at two attachment clip points.

Lift trim panel upward and away from door, disengage trim panel from upper retainer channel.

Disengage clip attaching latch linkage to back door handle.

Disconnect electrical connectors as necessary, including lower foot light, If equipped.

Remove door trim panel from door.

Awesome CHRYSLER TECH!  Thanks for the help and super fast reply!  One more thing.  Whats the best way to get the "instrument panel center bezel trim" off without snapping it?

trim stick or small flat head screw driver  dont pry hard

Thanks CHRYSLER TECH again!  One more thing.  Where should I start to take off the Bezel?  Like where is the best place to place the Flat Head Screw Driver to start to pry it.  Sorry if these are stupid questions. :)  Thanks in Advance!

on the side  ne place

Ok cool.  Thanks For al your help CHRYSLER TECH!

Hey Chrysler Tech.  I just noticed that the Speaker Grill on the door looks like it's molded onto the panel.  Does it come seperate?  I know you said Disengage the Speaker Grill clips but I can't seem to locate them.  Any tips on how I would go about taking it off?

speakers   it the whole door trim panel not just a grill
REMOVAL

1. Roll door glass down.
   Disengage two clips attaching speaker grille to door trim panel. They are at the front of the grille, one near the top, and the other one at the bottom.
   Remove three large washer-headed screws surrounding the speaker (Lower Door Trim Panel Removal).
   Remove access cover at front of door trim panel. Remove by prying at its rear edge (Mirror Bezel and Door Trim Access Cover).
   Remove red courtesy reflector from lower tail or door. Disengage by prying at screwdriver notch at bottom of reflector.
   Remove flag trim panel from door by prying off at two attachment clips points (Mirror Bezel and Door Trim Access Cover).
   Remove seven screws attaching door trim panel to door: (Lower Door Trim Panel Removal) and (Mirror Bezel and Door Trim Access Cover).
   
2. One screw is located at lower rear screw pocket.
   
3. Three screws located along the bottom of door.
   
4. One screw located inside handle opening.
   
5. One screw located at the upper front.
   
6. One screw in the pull cup.

Disengage two hidden clips attaching at the rear of the trim panel, by prying off at two attachment clip points.
Lift trim panel upward and away from door, disengage trim panel from upper retainer channel.
Disengage clip attaching latch linkage to back door handle.
Disconnect electrical connectors as necessary, including lower foot light, If equipped.

Remove door trim panel from door.

Hey Chrysler Tech.  I looked very carefully at my Door panel.  Here is what I don't get.
 
"Disengage two clips attaching speaker grille to door trim panel. They are at the front of the grille, one near the top, and the other one at the bottom.
Remove three large washer-headed screws surrounding the speaker (Lower Door Trim Panel Removal)."
 
The Speaker Grill Does not come off nor does it looks like it can come off..  I didnt see any signs of these clips you talk about.  I also don't have some things you mention liek the reflector and such.  I have a 06 Sebring Sedan if that matters.

if u took out the 3 washer screws then u took off the grill already look at the pics for the screws needed


Thumbnail Image



Thumbnail Image

Like I don't even know where to start besides the roll down the glass window :)  You say disengage the clips on the speaker grill but I cannot find any clips what so ever.  Are the 3 washer screws the ones at the bottom of the door?  Sorry dude but i'm really confused right now :)

HELP me Chrysler Tech! :)

It sounds like its a complete door panel removal.  Most chryslers dont have speaker grilles anymore we can make more money selling a complete door panel  :)  j/k i feel bad tellin people that though.  i think he is saying the screws are located near the grille not for the grille i cannot check for sure my login with dcx is down for an update right now.

Ok.  Thanks ace.  If you can find out that would be great.  My only day off is Friday of next week so if it's nice outside I will attempt it then.  Any more information would be great also.   Thanks guys for all the work.  Keep it up :)

?

The picture you posted also looks nothing like my door.  Thats a Sebring Convert. Door.  Ihave the 4 door Sedan Sebring.

Hello?

ok  there are 2 screw covers 1 in the door handle.and 1 in the door grip 2 screws on lower half of the door panel. Take them all out then with a trim stick  or screw driver  pry the clips and remove the door panel then u can get access to the speaker.

They are just clips?  I don't want to pry and break something off.  I'll try it on Friday.  Thanks Chrysler tech!

Meh.  I Tried again today.  Don't feel like breaking anything.  I'm gonna take it to Circuit City and let them do it for the $40.00 they charge.