I've been looking for it but i cant find it. It would seem that its inside the instrument cluster cause when turn signals are on i feel the vibration but i cant be too sure. Anybody know where they are?

BTW i'm trying to put LED turn signals but without replacing the flasher it will blink too fast.

 

the click u are hearing is just a noise the cluster makes there is no more flasher relay the front IPM does the pulsing on and off of the lights.

The CCN collects data and provides control signals for the following electrical equipment via the CAN data bus:

Gauges
Interior lighting controls
Variable-intensity cluster lighting and illumination of instrument panel mounted equipment
Vehicle Theft Alarm and Sentry Key Theft Deterrent System
Power door lock system controls (automatic locking, and Remote Keyless Entry locking and unlocking)
Headlamp switch actuation signal
Steering wheel radio actuation signals
Accessory power delay relay control
Wiper control
Turn signal flasher audible click
Heated seat actuation signal (if equipped)
UConnect® Hands-Free, Voice-Actuated Communication system actuation signal (if equipped)
Display of the outputs for the HomeLink® universal home security system and compass (if equipped)
Illuminated entry system
Key-in-ignition warning chime
Seat belt warning chime and lamp (Including BeltAlert®)
Door ajar warning indicator
Liftgate/trunk ajar warning indicator
LIN master module

 

Does that mean he does not need to replace anything else to convert the signals to LED?

 

So then theres no way to place led's as my turn signals. I've tried load equalizers but that didnt work either.

Now what????

 

i have no idea if u can do it or no U asked where teh flasher was at I dont know anything about any custom setup u are trying to install.