Computer code meaning
#1
Computer code meaning
Dear sirs.
I own a 2005 Stratus R/T turbo , and usually I do my own maintenace and repairs to my cars.
I bought this car new in Mexico, but this was manufactured in Arlington U.S.A plant, as at that time the Stratus plant in Mexico was closed.
The problem is that going on the road the motor suddenly stops or runs rough, I turn off the ignition wait a little ,start it again and in short time the motor smooths out and runs ok as normally does, with lots of power.
This happens two or three times per day
In the instrument panel I got the engine warning icon so I did the ignition key code retrieve procedure and got the following codes: P 0339 and
P 0335. Somebody in this forum could be so kind to let me know what this codes mean? I will appreciate your help .
Guayo
I own a 2005 Stratus R/T turbo , and usually I do my own maintenace and repairs to my cars.
I bought this car new in Mexico, but this was manufactured in Arlington U.S.A plant, as at that time the Stratus plant in Mexico was closed.
The problem is that going on the road the motor suddenly stops or runs rough, I turn off the ignition wait a little ,start it again and in short time the motor smooths out and runs ok as normally does, with lots of power.
This happens two or three times per day
In the instrument panel I got the engine warning icon so I did the ignition key code retrieve procedure and got the following codes: P 0339 and
P 0335. Somebody in this forum could be so kind to let me know what this codes mean? I will appreciate your help .
Guayo
#2
P0335 is the crankshaft position sensor. Can't find p0339 on the list anywhere. Skips from 335 to 340. I'm assuming this is a coupe...correct? The crank sensor is located behind the timing cover. You'll see a wire pigtail coming from top of engine and running into front of cover. You don't have to take off the belt. Not saying that's what it is, because it may not be. Could be wiring issue. I've seen that DTC go both ways. But your symptoms point to sensor itself.
Last edited by TNtech; 09-12-2010 at 10:06 AM.
#3
Thanks for your answer, yes its a 5 place car, now 'm getting also P 16 code , I'm going to check the c/shaft PS and associated wire harness by now.
Thanks thanks a lot.
Eduardo
Eduardo
Thanks thanks a lot.
Eduardo
Eduardo
Thread
Thread Starter
Forum
Replies
Last Post