2000 chrysler concorde 2.7l not shifting
 

I have a 2000 chrysler concorde 2.7 liter has ran great up until am onth ago.Im now in "limp mode" the check engine light is a permanent the speedometer does not move it shifts rough and occasionally dies out on me when i start it.ive replaced a speed sensor input some hoses,spark plugs and map sensor all to no relief.id like some assistance is the problem with the speedometer cluster not working .i can start it and when it dies shift it to neutral and it runs .any help would be appreciated

the output speed sensor is for the spedo hence the word OUTPUT

is the output the cause of all the problems then

I cant tell u that U have not told me any codes in the computer

reply
 

well the speed sensor got the speedometer to start working and got it out of second gear.the only code that comes up now is map/baro ckt high imput still dies out on me i replaced that a few weeks ago and it was a new part.any assistance would be great

repeat

I cant tell u that U have not told me any codes in the computer

the one code now is p0108

map sensor issue

before i bought a new one it read low input i replaced it and now says high input

I replaced the Map sensor in it and put some heet in the fuel tank.it started up last night but not at first and this morning then it died on me again.any suggestions im still getting the p0108 code

now U need a volt meter U will have 2 wires that will have 5v and one that has a ground with the key on see which U are missing

hopefully last question.i checked the housing that plugs into the map sensor i have 3 wires and one of them is loose would that be causing the problem

possible in a sense u would be loosing a 5v or a ground if it was not touching the connector

and if im losing that voltage that would lead to it dying out? what would be the best way to secure it

if the clip that hold the wire into the connector is broken then U replace the whole connector U can get wire repair kits from Chrysler parts dept.