How to remove lower cladding (LHS)
#1
07-23-2009, 04:16 PM
How to remove lower cladding (LHS)
I recently got into a fender bender, and am trying to remove the lower cladding (the part BELOW the outside of doors, that comes up and covers a small part of the wheel well on the front of the car).
It has they little black pins that hold it in place, and I can't figure out how to remove them. There are two on behind the wheel, and one inside the door sill. Are they reusalbe? This is my last hang up before I can get this thing out. I am about to drill them out, but don't konw how what to use to replace them.
It has they little black pins that hold it in place, and I can't figure out how to remove them. There are two on behind the wheel, and one inside the door sill. Are they reusalbe? This is my last hang up before I can get this thing out. I am about to drill them out, but don't konw how what to use to replace them.
#2
07-26-2009, 04:50 PM
ok, after some poking around...
they are plastic rivets. I had to drill them out, and buy a rivet gun from harbor freight. 14.99 later, I have some very OEM looking attched fender/wheel wells.
they are plastic rivets. I had to drill them out, and buy a rivet gun from harbor freight. 14.99 later, I have some very OEM looking attched fender/wheel wells.
Thread
Thread Starter
Forum
Replies
Last Post
Dan400Man
300M, Concorde, LHS, New Yorker
4
02-02-2013 01:18 PM
Vandal_Mav
Chrysler 300, 300C & 300C SRT-8
2
05-19-2005 09:58 PM
