Front Brake Trouble
 

My wife drives a 2004 Chrysler Sebring Touring 2.7, and the other weekend I was attemping to replace her front brakes and front rotors. I took the wheel off removed the anti rattle clip, and removed the protective caps for the caliper guide pins. Once I tried removing the guide pins none of my allen wrenches fit in the whole, one was too small, and the other was too big, is there a special size needed to remove these pins? Are the guide pins an allen size, or are they torex? I feel dumb for asking how to remove caliper guide pins because I've done this many times and other vehicles, but I figure instead of frustrating myself too much I'll ask for help.

So any help anyone could give I will greatly appreciate it!!!

Thanks!

It's an odd size, something like 7mm, I don't remember exactly but I remember that it was a size that never seems to be included in a set. Anyway, it's metric, so you'll need a metric set. If your set is metric and it's between two of your sizes, go to Sears or someplace where they'll sell you the one in between.

Ok cool, thanks I'll stop at Sears tomorrow, thanks for your input!

You were right, it was hex size 7mm. Success today replacing my wife's front brakes and front rotors, thanks for your help, dcotter0579!!!!