so i have a 01 sebring, 3 months ago the tcm was replaced and worked fine, the water pump went so i did a motor rebuild. when i started to drive it wouldnt shift out of second gear but would go reverse and park. i cleared all codes and still has the limp mode problem. no codes yet and all fuses and relays are good. any ideas?

 

What are you reading the codes with? A standard OBD II code reader probably won't read transmission codes.

 

none right now, but there was p0700 i think just said trans controller. i know one was probly fluid level but level was good

 

u will need a more powerful scanner to get into the trans computer to see what the real codes are.

 

pulled up 0605 and 1165
internal r.o.m. and power up at run

 

well replace the tranny computer to start that is one that U will need to have done regardless if the other is corrected by replacing it then all is good if not deal with it after.