Chrysler Forum - Chrysler Enthusiast Forums

Chrysler Forum - Chrysler Enthusiast Forums (https://www.chryslerforum.com/forum/)
-   Chrysler 300, 300C & 300C SRT-8 (https://www.chryslerforum.com/forum/chrysler-300-300c-300c-srt-8-17/)
-   -   ? on replacing rocker arm assemblies (https://www.chryslerforum.com/forum/chrysler-300-300c-300c-srt-8-17/replacing-rocker-arm-assemblies-31692/)

Jim Stutte Mar 12, 2020 05:07 PM
? on replacing rocker arm assemblies
 
The Haynes repair manual says when installing the rocker arm assemblies the camshafts must be put in a no load situation, neutral position, TDC. Is this necessary? The valve train is always in a loaded situation some valves opened some closed. 2007 v6 3.5 engine. Who has replaced the rocker arm assemblies? I was just going to place the engine at top dead center on #1 and replace the shafts. Thoughts please.
jim

Jim Stutte Mar 16, 2020 09:09 PM
Figured it out, This site is about as useful as square ball.

Jceofx Jun 28, 2022 06:03 PM
?
 
Originally Posted by Jim Stutte (Post 113875)
The Haynes repair manual says when installing the rocker arm assemblies the camshafts must be put in a no load situation, neutral position, TDC. Is this necessary? The valve train is always in a loaded situation some valves opened some closed. 2007 v6 3.5 engine. Who has replaced the rocker arm assemblies? I was just going to place the engine at top dead center on #1 and replace the shafts. Thoughts please.
jim
What was the solution if you don't mind my asking. I'm currently doing the same thing and was wondering this myself.


All times are GMT -5. The time now is 01:44 AM.


© 2026 MH Sub I, LLC dba Internet Brands