hi i have a 2000 chrysler neon the heaters dont work they will blow a little heat if they are on a little bit but if i turn them on more they just blow cold and then if i speed up they just blow cold air can any 1 help

 

the blend air control is done by a cable. Can u feel the cable bindup or not go all the way to cold and hot?
And what work if any has been done like a coolant flush or change your coolant and what is the level of your coolant ne way?

 

hi i dont no when the fluids were changed i have only had the car for 5 weeks the coolant level is around the fill line and i have taken the panel of in the dash to se if the cable had sliped of but it all seems to be fine would the fact that it has a pipecross induction kit on it make any diffrence to the heaters

 

what is a pipecross??? what is it hoked up to?

 

the whole are intake box has been replaced with a performance air vent the pipecross is the part that conects to the engine and curves around to the gap going down to the bottom of the bumber were the air filter conects to it

 

very simalar to this

 

that should not have nething to do with it heaters. Warm the engine up and feel the 2 hoses that go into the firewall that pumps the coolant into the hearer core are both hot or is one colder then the other?

 

were would the firewall be

 

also when the car is idel and in park the fan kicks in every couple of mins and if it is the two pipes that run frum the rear wall off the engine bay they are both hot

 

then u will need to take it to some one to take the dash out and see if there is a door prob or a motor prob.