1998 Chrysler Sebring No start and no spark
#1
1998 Chrysler Sebring No start and no spark
We have a 1998 Chrysler Sebring with a 2.5 liter v6 engine. It turns over but does not start and we have no power to the distributor. We have changed distributor, pcm, crankshaft sensor, wires, plugs and relays. Trying to figure out how to diagnose it from here. Any ideas??
#2
Get the codes out of the computer and go from there. The car has an on-board diagnostic system to find what is wrong. Make use of that before you run around replacing expensive parts *****-nilly.
If there's no power to the distributor, it makes no sense to replace the distributor. First find out why there's no power to the distributor.
If there's no power to the distributor, it makes no sense to replace the distributor. First find out why there's no power to the distributor.
#6
Did you reslve this issue?
If so ! what was the fix?
thank you Plugngo
Thread
Thread Starter
Forum
Replies
Last Post
WillQRose
Chrysler 200 & Sebring
19
10-18-2018 07:18 PM
clayborne
Chrysler 200 & Sebring
5
12-15-2010 10:41 PM