For a while I had been getting that single click when trying to start my 1999 300m and after being advised that it was the contacts on the starter I put a new starter in. Now when I try starting the car I just get the spinning of the bendix but it isn't engaging the flywheel. This thing was a huge pain to put in, so I wouldn't be surprised if something is loose but where should I be looking?

 

did it get seated fully into teh housing?

 

I would have changed the ignition module first. Same symptom as the starter and much much easier to change. I've changed too many starters when that wasn't the problem.

 

there is not am ignition module on any Chrysler cars from 96 and up.

read the post to what he says also

 

Ignition switch ( module ) I've changed many. 98-04 LHs all had them. Part# 05014176aa. Much cheaper then a starter.