P2017, P1004, P1005 throwing on every startup
Thread Starter
|
Junior Member
Joined: Apr 2023
Posts: 1
P2017, P1004, P1005 throwing on every startup
Hi all,
My 2008 Sebring Limited Convertible (3.5L) is throwing these codes every time I start the engine. I have confirmed this using multiple code readers and an OBD <--> PC interface.
P2017 - Active
P1004 - Pending
P1005 - Pending
I have already replaced the runner actuator (with the big flap) towards the rear of the car. I confirmed that the return spring wasn't working on the original part, but I'm still getting these codes. I have ordered the short runner actuator with the little nub on the end (this one is closer to the front of the car than the other actuator). Any thoughts on what's happening here? I'm hoping I can avoid replacing the entire intake manifold.
My 2008 Sebring Limited Convertible (3.5L) is throwing these codes every time I start the engine. I have confirmed this using multiple code readers and an OBD <--> PC interface.
P2017 - Active
P1004 - Pending
P1005 - Pending
I have already replaced the runner actuator (with the big flap) towards the rear of the car. I confirmed that the return spring wasn't working on the original part, but I'm still getting these codes. I have ordered the short runner actuator with the little nub on the end (this one is closer to the front of the car than the other actuator). Any thoughts on what's happening here? I'm hoping I can avoid replacing the entire intake manifold.
Thread
Thread Starter
Forum
Replies
Last Post
SCme
Chrysler Pacifica
3
Jul 29, 2017 09:36 AM
