Plenum support bolts
Thread Starter
|
Junior Member
Joined: Mar 2010
Posts: 4
Plenum support bolts
Hi,
On a 97 Sebring with the 2.5L, it is necessary to remove the intake plenum to get at the rear plugs. I have everything disconnected, but cannot seem to loosen the two rear plenum support bolts. There is no room to work. I have tried various universals on the socket, offset box end wrench, etc. Is there a trick to this I am missing?
Thanks
Mark
On a 97 Sebring with the 2.5L, it is necessary to remove the intake plenum to get at the rear plugs. I have everything disconnected, but cannot seem to loosen the two rear plenum support bolts. There is no room to work. I have tried various universals on the socket, offset box end wrench, etc. Is there a trick to this I am missing?
Thanks
Mark
Thread
Thread Starter
Forum
Replies
Last Post
fakegreasemonkey
Chrysler 200 & Sebring
9
Sep 12, 2016 02:44 PM
wylecoyote
Chrysler Pacifica
1
Sep 21, 2010 03:55 PM
