2013 300C John Varvatos V6, RWD - I have 8.4 inch screen (so minimal ac/heat buttons) and had both the driver side actuator doors replaced a couple weeks ago after dealer wanted to replace heater core and everything for $2500 - I just had the 2 actuators replaced, $200 instead. But when I start the vehicle and turn on either AUTO A/C heat setting or manually operate it, the system will cycle between hot & cold and cycle between all actuator door locations - left/right/defost/panel/floor/mix for a good 5+ minutes before it settles and stays where I have it set in MANUAL mode. I thought it would correct itself over time, but has not improved at all. In AUTO mode, after it settles, it may cycle intermittently after driving awhile and needing to auto-adjust. I have seen in older threads/vehicles that there's a "hold these buttons for 5 seconds" type procedure that will reset the system to stop this. Any ideas if my car has something like this OR other ideas to correct this? Thanks in advance!

 

Hi NeutronCity,

We sincerely regret to hear of your concerns! If you are unable to receive more feedback from here, please feel free to send us a private message as we would be glad to see how we can assist further.

Alex
Chrysler Cares