2009 Hybrid - No Backlight on HVAC controller
#1
2009 Hybrid - No Backlight on HVAC controller
Hey guys Im about to take delivery on a 2009 Aspen Hybrid in the next day or 2. During my test drive I did notice in the dark that the backlight to see the HVAC controls were out. I downloaded the manual and was looking though the fuse section and couldnt figure out which one it could possibly be, IF ANY.
I was hoping I would be able to fix it on my own as if I got the dealership to look at it they would end up charging me an arm and a leg to change a fuse or tell me I would need a whole module.
If you guys could point me in the right direction in which fuse it could possibly be or im SOL and do need to get a new module. Or could it be a wiring issue? Any help would be greatly appreciated.
Thanks and super excited owning my first Chrysler!
I was hoping I would be able to fix it on my own as if I got the dealership to look at it they would end up charging me an arm and a leg to change a fuse or tell me I would need a whole module.
If you guys could point me in the right direction in which fuse it could possibly be or im SOL and do need to get a new module. Or could it be a wiring issue? Any help would be greatly appreciated.
Thanks and super excited owning my first Chrysler!
#2
I know its a old question but had the same issue and may help someone else. There are 3 "neo wedge t4" bulbs when you remove the climate control board. These are not common bulbs but found mine on a popular auction site for around $1 each.
#3
I may go LED on these as mine are out on my 08 as well. These must get too hot as they are the first ones to go. I hope the LED brightness doesn't make them stand out too much. Anyone else done any LED bulbs in the backlit dash components?
Thread
Thread Starter
Forum
Replies
Last Post
docdrs
Chrysler Aspen
1
09-17-2012 01:52 PM