year make model

I have an 07 pacifica, just replaced the blower motor behind the glove box without issue. However, i can't get air to blow out the vents now. What am I missing?

Blower motor
 

I have an 07 pacifica, just replaced the blower motor behind the glove box without issue. However, i can't get air to blow out the vents now. What am I missing?

did you also replace the resistor? had ISSUES WHERE TEH BLOWER MOTOR WAS WIRED UP BACKWARDS TURNING THE FAN THE WRONG WAY. after Market CRAP LOL

Fixed
 

The wiring from the motor to the little plug was backwards. Just had to swap the wires. Works like a charm now.

yep thats what I was talking about they wire it up backwards.

Folks thanks. I seem to find it extremely hard to get the screw behind the HVAC housing out. I can barely get 1 finger to the rear..
what Am i doing wrong?
From the instructions, i can slightly lift the side cowl and get the carpet back.
after removing air circulator.
i can get the 2 screws on the HVAC duct in front out. 1 screw at the back left out too, but cannot get the one at the back right.

The one going from top to bottom in the front right. thats easy too.
what the trick/method to get the rear right screw on the HAVC housing?

use a 8mm swivel 1/4/ socket

Thanks Chrysler tech. Will give it a shot this weekend.