Originally Posted by Vmaxxer
(Post 89030)
mail with last 2 pics send :)
|
done :cool:
|
Originally Posted by Vmaxxer
(Post 89019)
Found some more pics.
1 of the backside of the light switch panel (arrow points to foot of bulb holder) And one of the bulb with arrow pointing to the metal strips you can "unwrap" so you can replace the bulb in the holder. Thank you, Dominic |
Originally Posted by Vmaxxer
(Post 89013)
If we are talking about this panel the bulbs should look like these (but longer and with a blue tip)
|
Strange...But possible.. I replaced the panel some time ago and found that there are differences in panels off factory.
Some where delivered with headlight adjustment (like in my voyager) and others not. Panels are roughly the same but with various functionality activated. I soldered an extra pin on my replacement panel so headlight adjuster's worked on my new panel (clever me :D ) Maybe in your case the panel was delivered without illumination for some obscure reason? :confused: I would indeed get the bulbs from a scrapyard (or even a complete panel) |
If you struggle to get them drop me a message, I just recently got a pack of holders and green led bulbs for my dash illumination that I ended up not needing so I can post you a couple?
|
Originally Posted by andyb2000
(Post 89017)
Also, the bad news on the heated seats illumination, I had quite a challenge get in doing this on my old gv.
Removing the whole centre console is easy, two screws at top, two hidden under a think grey plastic panel at Base (just above cigarette tray) and then prise the whole fake-oak effect panel from one of the sides, unclip the control cables (push red clip in then press down to release) on mine there were 3.one top, two middle for climate control. Now the harder part, the heated seat and hazard indicator piece you gently prise out. I used 3 or 4 thin screwdrivers simultaneously in the notches. Keep it flat as when you take it out you need to keep the switches in the right position. Once out you'll see the problem. Panel illumination is by a set of soldered in bulbs. Who on earth does that! What I did was de-soldered them and replaced them with 12v leds in their place. Was fiddly soldering but in the end it worked great. Not sure on your soldering and skill level but might be worth taking a look as getting at them isn't a huge job. Good luck what size led did you have to get for this ? any pics |
wow, this is an old thread!
The LEDs I used were 2.5mm as they are quite small to fit onto the boards, but the soldering wasn't anything difficult to do. |
im not to bad at soldering . do you have any pics of the end result ..
|
All times are GMT -5. The time now is 09:03 AM. |
© 2024 MH Sub I, LLC dba Internet Brands