2004 Sebring Convertible Water Leaking from rear of the Engine Block
#1
2004 Sebring Convertible Water Leaking from rear of the Engine Block
I'm working on a 2004 Chrysler Sebring Convertible 2.7L DOHC 24 Valve. It was leaking water between the transmission and the bell housing meets the engine block. I was told that this was most definitely due to a bad freeze plug.
There is a hole in the engine block and it is not a freeze plug. This is where the water is pouring out. If you look at the picture you can see where I circled the hole. This is where the water is pouring out.
Any suggestions would be greatly appreciated.
Image - TinyPic - Free Image Hosting, Photo Sharing & Video Hosting
There is a hole in the engine block and it is not a freeze plug. This is where the water is pouring out. If you look at the picture you can see where I circled the hole. This is where the water is pouring out.
Any suggestions would be greatly appreciated.
Image - TinyPic - Free Image Hosting, Photo Sharing & Video Hosting
Thread
Thread Starter
Forum
Replies
Last Post
RacingJunk
Archive - Classified Feed
0
09-02-2013 05:48 PM
2003sebring
Chrysler 200 & Sebring
3
03-23-2011 07:55 PM
jonny
Chrysler Voyager & Town & Country
0
03-10-2011 04:37 AM