my 300m showing codes, po700,p1793,po455, andp1391. also sounds as, it's about to stall out, please help. thank you..gr85guns.

 

have u even looked up what the codes are?

 

P0700 - EATX Controller DTC Present - This SBEC III or JTEC indicates that the EATX or Aisin controller has an active fault and has illuminated the MIL via a CCD (EATX) or SCI (Aisin) message. The specific fault must be aquired from the EATX via CCD or fro the Aisin via ISO-9141

P1793 - Not in my book

P0455 - Evap Leak Monitor Large Leak Detected - A large leak has been detected in the evaporative system.

P1391 - Intermittent Loss of CMP or CKP - Loss of the Cam Position Sensor or Crank Position Sensor has occurred. For PL 2.0L

 

My 2001 300m is in the shop as we speak with this same problem. Hold on to your seat. The dealer ran a smoke test and low and behold the fornd the leak. Wouln't you know it is at the very top of the gas tank. They have to drop the takk to repair. They informed me that due to the rusty tank straps the would have to install new ones. Total cost of leak repair $456.00 No repair on this vehc-icle is cheep. But I still love it.

 

From ltr: Just got my car back from dealer. Hasd small leak detected. besides tank straps the had to replace taks pump and solanoid for a tota;l cost of $800.63. Gawd these cars are expensive to repair.