300M, Concorde, LHS, New Yorker Discuss the Chrysler LH platform cars within.

2004 Concorde LXI Power window/ATC issue.

Thread Tools
 
Search this Thread
 
  #1  
Old 08-21-2009, 09:42 PM
Midee1's Avatar
Junior Member
Thread Starter
Join Date: Aug 2009
Posts: 1
Default 2004 Concorde LXI Power window/ATC issue.

About a week ago I got into my car and tried to roll down the windows. No luck no even a buzzing noise. I decided not to worry about it at the moment and just turn the air on. Low and behold the ATC would not come on either. Needless to say it's not pleasant to drive in 90+ degree weather so it's parked for the time being.

I check every fuse, breaker and relay that I could find and nothing is blow according to the OHM meter.

Any other suggestions where to look?
 
  #2  
Old 07-21-2012, 07:52 AM
nelsonkn's Avatar
Junior Member
Join Date: Jul 2012
Posts: 17
Default

I'm having the same issues and hoping for a response. Are your dash lights on? (abs, brake)
 
  #3  
Old 07-21-2012, 08:22 AM
CHRYSLER TECH's Avatar
Super Moderator
Join Date: Mar 2006
Location: Norcross GA
Posts: 8,793
Default

do u have voltage on the fuse?
 
  #4  
Old 07-21-2012, 08:39 AM
nelsonkn's Avatar
Junior Member
Join Date: Jul 2012
Posts: 17
Default

I didn't test any fuses. I just pulled them all one at a time to see if any were blown. From looking around online I think it's a common chrysler issue but nobody has posted the actual fix. Some say it's an ignition switch. Some say it's a fuse. Some say it's a relay.
 
  #5  
Old 07-21-2012, 09:45 AM
CHRYSLER TECH's Avatar
Super Moderator
Join Date: Mar 2006
Location: Norcross GA
Posts: 8,793
Default

why dont u then check to see if there is power on the fuses u check first then we can go from there.
 
  #6  
Old 07-21-2012, 09:51 AM
nelsonkn's Avatar
Junior Member
Join Date: Jul 2012
Posts: 17
Default

Will do.
 
  #7  
Old 07-21-2012, 11:33 AM
nelsonkn's Avatar
Junior Member
Join Date: Jul 2012
Posts: 17
Default

I tested it and no voltage. Not 100% sure I did it right. I turn the ignition to run without cranking the car, pulled the fuses and put the leads in each side of the fuse spot. There were a couple I tested and did not get a reading but tested again and did. Some gave me no reading at all. So, if there is no voltage going to the fuse, than what?
 
  #8  
Old 07-21-2012, 05:14 PM
CHRYSLER TECH's Avatar
Super Moderator
Join Date: Mar 2006
Location: Norcross GA
Posts: 8,793
Default

no u did not do it right on each fuse there is a little spot of metal u can touch it with a volt meter or test light and it will keep the circuit complete test both side of the fuse if one has power and the other does not the fuse is blown.
 
  #9  
Old 07-21-2012, 05:22 PM
nelsonkn's Avatar
Junior Member
Join Date: Jul 2012
Posts: 17
Default

So no voltate means?
 
  #10  
Old 07-21-2012, 09:58 PM
CHRYSLER TECH's Avatar
Super Moderator
Join Date: Mar 2006
Location: Norcross GA
Posts: 8,793
Default

no power now u get a wire diagram and trace down where that power comes from and go from there
 


Quick Reply: 2004 Concorde LXI Power window/ATC issue.



All times are GMT -5. The time now is 02:58 PM.