Auto unlocking on Sebring 2007
#1
Auto unlocking on Sebring 2007
Hi guys,
I have one very stupid problem on my Sebring, when I start driving my all of my doors luck which is ok and normal BUT when I stop and put gear back to P doors are still left lock, every time when I'm driving somebody at back a have to unlock all doors, so please help me out how to enable unlocking or even how to disable autolocking
Thanks
I have one very stupid problem on my Sebring, when I start driving my all of my doors luck which is ok and normal BUT when I stop and put gear back to P doors are still left lock, every time when I'm driving somebody at back a have to unlock all doors, so please help me out how to enable unlocking or even how to disable autolocking
Thanks
#2
RE: Auto unlocking on Sebring 2007
techCONNECT ContentAUTOMATIC DOOR LOCKS The CCN controls the power locks when the door lock switch is activated. If the door lock switch is pressed for longer than eight consecutive seconds, the CCN will de-energize the door lock relay. The automatic door lock system can be enabled/disabled either by the customer or with the scan tool. Refer to the scan tool or the vehicle owners manual for enabling/disabling procedures. The CCN will automatically re-lock all doors if the above conditions are met and if any of the doors become ajar and then closes again. The power latches are also equipped with a thermal protection system which prevents the latches from burning out.
#3
RE: Auto unlocking on Sebring 2007
That's the way they are supposed to work. Older GM models used to unlock when the car was put in park, but Chrysler never did that.
You can disable the auto locking. There's a procedure in the owners manual.
You can disable the auto locking. There's a procedure in the owners manual.
Thread
Thread Starter
Forum
Replies
Last Post