Installing Power Wire Through Firewall
Thread Starter
Joined: Jan 2008
Posts: 2
Installing Power Wire Through Firewall
I have a 2002 300M Special, no I'm not rich like you guys, and I was looking for the
best place to provide a power wire from the battery, through the firewall, and into the
trunk so that I might provide power to my portable time machine...and the amp powering
my subs.
The specific problem being getting through the firewall. Can I use an existing grommet?
If I need to punch through where would be the best place? Any help is appreciated.
RELATED COMMENT: LOVE THIS CAR...a bit dissapointed with the sound system.
Jeffrey
best place to provide a power wire from the battery, through the firewall, and into the
trunk so that I might provide power to my portable time machine...and the amp powering
my subs.
The specific problem being getting through the firewall. Can I use an existing grommet?
If I need to punch through where would be the best place? Any help is appreciated.
RELATED COMMENT: LOVE THIS CAR...a bit dissapointed with the sound system.
Jeffrey
Joined: Mar 2007
Posts: 1
RE: Installing Power Wire Through Firewall
Best practice would be to use a existing route already there. If you need to drill through the wall go from the inside into the engine area. Be sure nothing is on the other side and install a grommet to keep the wall from eventually cutting into the wire or you could look here for other ideas http://www.the12volt.com/ohm/basics.asp
Thread
Thread Starter
Forum
Replies
Last Post
soulintent
Chrysler Crossfire & Crossfire SRT-6
0
Jun 15, 2011 07:54 PM
ecfilms123
Chrysler 200 & Sebring
0
Mar 25, 2011 10:53 AM
blondedriver
Chrysler 200 & Sebring
4
Jan 8, 2009 06:20 AM
