Hello, I have a problem with my Aspen 2007r 5,7hemi. After crash and repair all the error code C107C appeared to me. I deduced that the reason were bad indication range of brake pressure sensor: 100bar when brake pedal was release, up to 200bar when brake pedal was press max. According to my information the range should be between 0 - 100bar. After this I disassemble ABS module, I clean controller's and pressure sensor body's electrical terminals. Next I asseble this which resulted in a change sensor's range -25bar to 60bar and change error Code from C107C to C121D. Is there a possibility to calibrate or zeroing this sensor? Regards