2009 Chrysler town and country 3.8L

Ok folks I need help. A few months ago I started having a very soft brake pedal, as in almost to the floor to stop. I got a new master cylinder, bench bled it and installed it and then bled all the lines and let them run til the old fluid was gone and only the new pretty fluid flowed through. Unfortunately it didn’t help. Now tonight I just finished changing all rotors and pads and bled the lines for about 10min keeping the reservoir full. No air bubbles coming out of any lines. Put the wheels back on and put it back on the ground. I pumped the pedal about 30 times to get the calipers back right and Now the dang pedal goes all the way to the floor. I took it out for a short test drive and the freaking thing will barely stop. We are currently saving for a replacement vehicle. Over the years this van has been great for our family BUT an absolute money pit. I’m trying to avoid taking to a shop and it being tied up for weeks and a bunch of money. Anyone have any ideas?

 

Hey Kerry, did you find a solution? My 08 is doing the same thing after I replaced the front pads.