Break issue

Thread Tools
 
Search this Thread
 
Old Mar 12, 2012 | 10:39 PM
  #1  
shawn2k2's Avatar
Thread Starter
|
Junior Member
Joined: Jan 2012
Posts: 11
Default Break issue

So today and tonight I've had some issues, both are when the car is started.

I have little resistance with the break pedal, it goes right to the floor and I slowly slow to a stop, this will do it a few times than all of a sudden I'll have break pressure again and no problems..

Is this a symptom of air in the lines? Or could it be something else...
 
Old Mar 13, 2012 | 06:09 AM
  #2  
CHRYSLER TECH's Avatar
Super Moderator
Joined: Mar 2006
Posts: 9,135
From: Norcross GA
Default

yes or faulty master cyl
 
Old Mar 13, 2012 | 06:34 AM
  #3  
shawn2k2's Avatar
Thread Starter
|
Junior Member
Joined: Jan 2012
Posts: 11
Default

I beleive it to be master cylinder failure, these two times have been the only times it did it. If there was air in the system I think it would have presented beforehand and not correct itself while driving..

Does that make sense?
 
Old Mar 13, 2012 | 10:35 AM
  #4  
shawn2k2's Avatar
Thread Starter
|
Junior Member
Joined: Jan 2012
Posts: 11
Default

Just went out and checked, pumped the brakes a few times off, and pedal goes to floor, checked all 4 wheels and right rear has a nice puddle under the tire. My guess this has been the wheel cylinder instead...hopefully that's all it is
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
blindmutt
Chrysler 200 & Sebring
1
Dec 3, 2008 02:51 PM
jquinones
Chrysler Voyager & Town & Country
19
Mar 7, 2008 04:54 PM
iforgotmine
300M, Concorde, LHS, New Yorker
1
Dec 18, 2005 08:51 AM
iforgotmine
300M, Concorde, LHS, New Yorker
0
Jul 28, 2005 02:04 AM




All times are GMT -5. The time now is 02:06 AM.