Hi all
I have done a lot of research on this.
I am having slow acceleration-a lot of vibration and bogged down shifting.
Replaced map sensor and cam shaft sensor.-although no codes for them.
Nothing changed.
I replaced cam sensor because I read somewhere if vehicle runs better without it then it is bad. I replaced it and same exact symptoms.
Funny thing is without the cam sensor connector plugged in car ran much better.
I checked error codes without it plugged in and all I got was p0340(due to cam sensor not being plugged in). Other wise no vibration at all as cylinder 2 was evidently working fine.
I would consider leaving it off but car is hard to start without the cam sensor-took about 7 tries.
Any suggestions would be greatly appreciated-hopefully before I jump off the bridge-LOLOL

 

Sorry I forgot to mention I replaced all plugs and the coil on number 2 . Checked and am getting spark on all plugs.
I just cannot figure out why cylinder 2 will not operate when cam sensor is connected. But when disconnected works fine.

 

Too bad jac you are sol. ahahahahahaaaaa