po344 cam and crank sensors have been changed
#1
po344 cam and crank sensors have been changed
2004 Concorde LXI I've been getting this code for a long while. I replaced the the Camshaft sensor last fall (the car was not driven through the spring/summer and is my winter car). The only thing that changed when the sensor was changed is that it no longer stalls on me when the CEL comes on with this code...it used to stall driving down the road and not restart right away...that really sucked.
Anyway, I just got around to changing the crankshaft sensor...and that made no difference at all...So both sensors have been changed now and I'm still getting the code and going into limp mode.
What's next?
I haven't yet taken advantage of the recall to update the computer to prevent catalytic converter damage when driving in limp mode...I can't imaging that update would stop the code from appearing...would it?
Anyway, I just got around to changing the crankshaft sensor...and that made no difference at all...So both sensors have been changed now and I'm still getting the code and going into limp mode.
What's next?
I haven't yet taken advantage of the recall to update the computer to prevent catalytic converter damage when driving in limp mode...I can't imaging that update would stop the code from appearing...would it?
#3
If that's the case that could be my problem since the sensor was changed already...no? I'll get the update then try the Mopar branded sensor...thanks.
#5
concorde won't start
2004 concorde, after a short drive, say 30 miles, stop car to go into a store, come back out, car won't start. Motor turns over, starts after a couple mins. I have changed the crank shaft and cam shaft sensor twice. Runs good for a couple weeks, then here we are again. HELP!!!!
Thread
Thread Starter
Forum
Replies
Last Post
donnyohs
300M, Concorde, LHS, New Yorker
22
07-17-2009 03:19 PM
mygold2u
New Member Area
2
01-20-2009 01:20 PM