Ive experienced this problem as many others have. Everywhere I've read, says take a wire hanger or something and unjam the drain holes at the bottom of the quarter panel just in front of the wheel well.

I here to tell you that approach may not always work. As you may know, I bought a 97 Sebring to pluck parts from. Im in the process of stripping it. While I was pulling the Hydraulic motor and rag top. I noticed these two tubes running vertically behind the seat. Yep drains. Becase of the design (I had a word doc ready but its upload isnt supported) theres no way you can get a hanger or something in there to clear this up at either end.

There was a kink causing a blockage. This is what I pulled out of the parts car.



[IMG]local://upfiles/3114/E777777FBD724FE58D32839015EE7E99.jpg[/IMG]

 

I have pics at www.sumncguysebringparts.com of the tube shown in the intial post installed in the car and shows the routing.

Regards
Chris

 

so your saying that there are two drains running behing the back seat and thats where the water in coming from? i clicked on your link but it directs me to PCH.

thanks in advance.