CRD Cutting out AGAIN!! Please help me!
#21
I tested my MAF sensor and i found it bad! The output voltage is steady at 1,03 volt with engine running too.
I tried to disconnect the MAF plug and the engine runs better: much response and it cut out less. The engine light on the dash strangely remain off: the ECM does not notice that the MAF is unplugged. Is it possible?
Could be the bad MAF my problem?
I tried to disconnect the MAF plug and the engine runs better: much response and it cut out less. The engine light on the dash strangely remain off: the ECM does not notice that the MAF is unplugged. Is it possible?
Could be the bad MAF my problem?
Thread
Thread Starter
Forum
Replies
Last Post
richjones19772000
Chrysler Voyager & Town & Country
4
02-28-2014 02:20 PM