We have a 2012 Chrysler Town & County with less that 70,000 miles, which is super low mileage and should not be experiencing these issues. We recently had to replace the transmission which was completed at a Chrysler dealership. Since we got the van back we've had intermittent issues with it starting. We have changed the battery, the starter, and the battery cables twice. Each times we've had it towed to the shop they'll change one of the things mentioned then it will start for a couple of days and suddenly no start no crank. Every time we have it towed to them it'll start for them with no problem they tell us it will start every time. Once we get it home and drive for a day or two it won't start for us, it won't jump for us, it won't do anything. We've tried removing the battery cables and putting them back on and nothing. The last attempt we asked the shop to drive it as a delivery trunk until it acted out for them. It finally acted out and they changed the battery cables again and it started back up for them. We drove it for 3 days and now we're back to no start no crank. We are past being fed up with this van, the multiple tows and the fact that it's basically been in the shop for 7 months between the transmission and the starting issue. Also we have noticed the TCL and the ABS lights will come on and stay on when it doesn't start, not sure if that is related to this issue.

Any advice would be greatly appreciated.

 

The same dealer you had the trans replaced at is replacing the items mentioned ? I would be going for the oblivious stuff related to the transmission like range sensor of crank sensor depending on what the no start issue consists of.

 

No we’ve been taking it to a different shop. The Chrysler dealership we took it to for the transmission replacement was absolutely terrible!

 

Did you inform them that the trans was replaced and then this happening ?