PStar 3.6 Timing marks
#1
PStar 3.6 Timing marks
All,
I have a 2012 minivan with the Pentastar 3.6. I just replaced all lifters, rockers and the exhaust cam on the left side only. I have not started the right side yet. All dots, arrows and painted references were in place at assembly.
As a sanity check, I rotated the engine a number of times by hand from the crank bolt to see if everything lined up again. The paint references on the chain did not line up. They were about four teeth off, all else look good.
Is this normal?
Thanks
I have a 2012 minivan with the Pentastar 3.6. I just replaced all lifters, rockers and the exhaust cam on the left side only. I have not started the right side yet. All dots, arrows and painted references were in place at assembly.
As a sanity check, I rotated the engine a number of times by hand from the crank bolt to see if everything lined up again. The paint references on the chain did not line up. They were about four teeth off, all else look good.
Is this normal?
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
jeelocked
Chrysler Voyager & Town & Country
4
01-04-2017 04:23 PM