Hello all,

How easy is it to remove and replace the multi-function switch on an '04 Town & Country? Mine won't cancel when it is in the down (left-turn) position. I have to push it back up manually every time I make a left turn, and it's kind of a pain. The part is $50 at the dealer, and I'd like to just replace it myself. I haven't sprung for a service manual, so I don't have any instructions or diagrams. Are there any special tools required? Any tips would be appreciated.

Thanks,

Chris

 

REMOVAL
[ol][*]Disconnect and isolate battery negative cable.[*]Remove upper and lower steering column shrouds. Refer to Steering, Column, Shroud, Removal.[*]Disconnect wire connector from back of multi-function switch.[*]Remove screws holding multi-function switch to steering column adapter collar.[*]Remove the multi-function switch...................... let me know moe i'll get you some pictures[/ol]

 

 

1 - CLOCKSPRING WIRING

2 - STEERING WHEEL

3 - UPPER SHROUD

4 - FIXED SHROUD

5 - SCREW

6 - STEERING COLUMN MOUNTING PLATE

7 - NUT

8 - DASH PANEL STEERING COLUMN MOUNTING BRACKET

9 - STUDS 4

10 - STEERING COLUMN LOCKING PIN

11 - NUT/WASHER ASSEMBLY

12 - STEERING COLUMN ASSEMBLY

13 - LOWER SHROUD

14 - SCREWS

15 - STEERING WHEEL RETAINING NUT

16 - STEERING WHEEL DAMPER

17 - CLOCKSPRING

18 - SCREW

19 - MULTI-FUNCTION SWITCH MOUNTING/HOUSING

20 - PINCH BOLT

21 - STEERING COLUMN COUPLER

22 - PINCH BOLT RETAINING PIN

23 - DASH PANEL

24 - SILENCER SHELL

25 - INTERMEDIATE SHAFT SHIELD AND SEAL

26 - INTERMEDIATE SHAFT

27 - ROLL PIN

28 - STEERING GEAR

29 - FRONT SUSPENSION CRADLE
sorry about taking up so much space!!!hope this helped moe