I need to remove the timing cover on my 2010 3,8l T&C
In doing so, the Camshaft position sensor has to come out.
When refit it, ther should be some sort of "paper" spacer at the end.
Any suggestions on what to use, since I dont have the proper spacer available.

 

OEM Spacer is about .030" thick. I used 2 match book covers attached with a glue stick. Worked well.

 

Ok, so that equals to 0,762 mm.
Thanks

 

So, I took a sheet of laserprinter stickers, put 8 of them on top of each other, giving me a thicknes of around 0,75mm, used a 10mm hole punch to create a cirkular sticker, cleaned the sensor and sticked it on.