Help me to find Input Shaft bearing
#11
small update im getting there..car nearly ready its been 1.5 months.Took so long for only 2 reasons-- bad weather or no money
About input shaft bearing,,yes it is hold by 2 screws but it didnt came out ..tried hard. thats why i decided to kick it out from inside.
Now i have only Oil Pan gasket to replace..will be done tomorrow.All other parts fitted ,,a lot of them . done small test drive and luckily still had all gears Clutch was fitted without centering tool( just by eye) and seems fine. Because clutch slave cylinder came off (metal pin was rusty and snapped) and air got in i took all clutch system off and done good bleed. Now clutch better than before.
Its been long repair but i hope its worth it. I still gonna need one second hand injector but this is later.
Tomorrow if wont be any surprises then i hope finish that journey. Once im done i add photo of all parts that came off.
With all these jobs i should get MOT for 5 years
About input shaft bearing,,yes it is hold by 2 screws but it didnt came out ..tried hard. thats why i decided to kick it out from inside.
Now i have only Oil Pan gasket to replace..will be done tomorrow.All other parts fitted ,,a lot of them . done small test drive and luckily still had all gears Clutch was fitted without centering tool( just by eye) and seems fine. Because clutch slave cylinder came off (metal pin was rusty and snapped) and air got in i took all clutch system off and done good bleed. Now clutch better than before.
Its been long repair but i hope its worth it. I still gonna need one second hand injector but this is later.
Tomorrow if wont be any surprises then i hope finish that journey. Once im done i add photo of all parts that came off.
With all these jobs i should get MOT for 5 years
#16
its holding good enough for me but is it good enough for mot - will find out tomorrow. My rear brakes was rebuilt this year as well. replaced rear ceramic pistons(they had cracks on them) with new steel ones along with piston seals.and handbrake parts all new ,,all springs and shoes. But it was months ago..so life is full of surprises.
#17
DONE!!! 1.5 month long restore-rebuild-repair journey ended and Mot is passed without any advisories-questions-recommendation. But got comment from mot tester that - your car is in so good condition. What else can i want. Homemade mechanic as i am - using youtube and google and this Chrysler Forum members help. Thanks a lot for people in here who keep posting problems and who have answers for them. Keep up good work!!! Tomorrow i post pictures about parts i removed and then you see condition of them. Some are very shocking so 18+
#19
Here are parts that came off. One suspension arm end bushing seems to slip off, shocks so rusted also rear tracking rod. Rear brake discs and front strut from earlier this year. Front sway bar bushings so worn,,never seen these that bad. And rattle noise from transmission was caused by loose springs on clutch disc. Yeah,,what can i say.
Last edited by imtattoo80; 12-23-2015 at 10:19 AM.
Thread
Thread Starter
Forum
Replies
Last Post
chrysler1
Chrysler Voyager & Town & Country
0
12-21-2013 11:09 AM
musicfreak2195
Chrysler 200 & Sebring
3
10-08-2008 08:55 AM
carolinaislander
300M, Concorde, LHS, New Yorker
1
10-07-2008 06:47 PM